These halves are made in Europe and are the same thickness as the original pans. The inside edge starts at the center tunnel, including the bolt pattern area under the rocker. It is necessary to drill out the holes around the rockers but there is a dimple marked to drill from.
When replacing floor pans we recommend that you also replace your front support plates, seat tracks, jack receiver and your jack support and floor mat clips.
Note: Flat rate shipping of $200.00 to continental U.S. addresses.
In compliance with California Law, we are providing the following WARNING: Cancer and Reproductive Harm
The Thing Shop has the Largest Selection of VW Thing Parts in the World!